BCU370WI1FEU0D1

88601642
On-site housing for control and ignition
and monitoring of modulating
fan-assisted burners. For
Continuous operation with ionization monitoring
or UV monitoring with UV probe UVD.
Intermittent operation with UV probe
UVS. Display of the program status, the
Device parameters and the flame signal.
Manual operating mode. Diagnostics and
Setting device parameters via
optical interface and PC software
BCSoft. EU-certified. AGA approved.
Market: European market, EU-certified
Mains voltage: 230 V~, 50/60 Hz
Electronic ignition: Single-pole
Blower control: Relay 3 A
Flap control: Three-point step
Flame monitoring: Ionic
(Continuous/intermittent operation) or UV
(intermittent with UVS)
Digital input function: Monitoring
DGmax.
Electrical connection: With base
11 Minimum burner pause time tBP: 0 s
07 Burner start-up attempts: 1
22 Switch-on delay time tE: 0 s
21 Pre-ignition time tVZ: 3 s
12 Safety time 1 Start-up burner/ignition
tSA1: 3 s
13 Flame stabilization time 1 bru./ignition bru.
tFS1: 2 s
14 Safety time 2 Start-up main burner
tSA2: 5 s
15 Flame stabilization time 2
Main burner tFS2: 2 s
29 Delay time rule release tRF: 0 s
10 Minimum operating time tB: 0 s
09 Safety time during operation tSB: 1 s
27 V2 in burner operation: One
08 Behavior after flame failure in the
Operation: Fault shutdown
02 Burner shutdown threshold: 1 micro A
17 UVS check (1 x in 24 h): Off
16 Operating time in manual mode: up to 5
Limited minutes: No
30. Custom password: ----
04 Air monitoring during pre-rinse: One
05 Air monitoring in the workplace: One
23 Gas pressure monitoring min.: Off
24 Function Digital Input: Monitoring
DGmax.
20 Blower pre-run time tGV: 3 s
25 Flap control: One
06 Pre-rinse on every start: One
18 Pre-rinse time tPV: 10 s
19 Rinse time tPN: 0 s