M1000 according to SNR: 1808-361
Badger Meter
1 transmitter M 1000
for measuring in a fully filled pipeline
For media with a solids content of max. 7% Ts
Installation: assembled / separated with X m cable
Housing: Cast aluminum powder-coated in IP 67
Cable entry: 2 x M 20
Ambient temperature: - 20 to + 60°C
Display: LCD
Conductivity: min. 5 µS/cm (20 µS/cm for demineralized water)
Outputs:
Analog output: 0/4 - 20 mA / 0 - 10 mA, flow direction is
displayed via a separate status output
Frequency output max. 10 kHz (open collector)
Status output:
min./max. alarm, preset, flow direction, fault message, freely configurable
Pulse output: 2 open collector, passive 32 VDC, 0-100 Hz 100 mA,
100 - 10,000 Hz 20 mA, optionally active
Configuration: via RS232 or keyboard
Optionally available: Hart / M-Bus / Ethernet (Modbus TCP/IP)
Measuring accuracy: ± 0.3% of measured value; ±2 mm/s of measured value
Reproducibility: 0.1%
Measuring range: 0.03 - 12 m/s
Flow direction: bi-directional possible.
Standard uni-directional (in the direction of the arrow)
Interface: RS232, RS485 and Modbus RTU
Empty pipe detection: On/Off; medium monitoring via separate electrode
Low flow suppression: 0-10%
Supply: 92 - 275 VAC
1 additional grounding electrode
installed in the flow meter
Material: Hastelloy C
-for non-earthed cables (e.g. plastic)-
1Magnetic-Inductive Flowmeter Type II
Measuring range 1.4 - 45 m³/h
Lining hard rubber, electrodes Hastelloy C
Lining with drinking water approval (WRAS certified)
Housing and flanges: painted steel
Temperature 0... +80°C, pressure max. 16 bar
Overall length 200 mm
Connection flanges DN 40 PN 16
